Updating oiling system hd flathead
The HV pump may require oil pan modifications (see Notes tab for details).
Fits 1932-1953 Ford and Mercury flathead V8 engines.
Slide the HDD 2 to the right until it’s disconnected from the motherboard and remove it. These laptop has three antenna cables but only two are used.
One of the antenna cables connected to the main contact on the wireless card and the second one is connected to the auxiliary contact.
An engine's bore-to-stroke ratio tells us something about how it was designed and how it will perform.
Engines that have nearly the same bore and stroke (a 1:1 ratio or so) are referred to as "square." Engines with a bore appreciably larger than the stroke are referred to as "oversquare," and the opposite, with a stroke larger than the bore, is "undersquare." An undersquare engine tends to be tall.
Bill Harley and Arthur Davidson had really only figured out that when they wanted to go faster, all they had to do was make a bigger engine! There are two ways to make engines bigger: You can increase their bore (the diameter of the cylinder) or their stroke (the distance the piston moves up and down inside the cylinder). Don’t forget to remove two screws hidden in the CD/DVD drive bay. Start separating the speaker cover from the top cover. Insert the guitar pick between the speaker cover and case and slowly move along the side. In order to remove the cable, you’ll have to unlock the connector first. Be careful, it’s still connected to the motherboard. By the way, it’s not necessary to separate the display panel assemble from the base in order to take it apart. 480481-001 for notebooks equipped with Intel processors.A year later, the Harley D was joined by the V models which sported a 74 ci version of the Flatty.Six years later, in 1936, an 80 cubic inch Flathead became available with the introduction of the Harley model UH and ULH motorcycles.
Remove (loosen) four screws securing the hard drive and memory cover. Slide the HDD 1 to the left until it’s disconnected from the motherboard and remove it. Disconnect two antenna cables from the wireless card.